NX 7.5 Part Attributes
NX 7.5 Part Attributes
(OP)
I would like to add a part attribute to my template drawing file.
The attributes are currently listed in the order that they were added.
I would like this new attribute to appear towards the top of the list.
The only way I can figure out how to add the new attibute to a certain position in the list, is to delete all the attributes and put them back in the order that I would like them listed.
Is there a way to reorder part attributes after they are added to the part?
It really is not a big deal for me to delete the attributes and put them back in, but there is one attribute that I cannot delete because I get the error that it is being used in a table or annotation and cannot be deleted ~ but I deleted the annotation that it was used in, and is not being used anyplace, so I should not be getting the error
The attributes are currently listed in the order that they were added.
I would like this new attribute to appear towards the top of the list.
The only way I can figure out how to add the new attibute to a certain position in the list, is to delete all the attributes and put them back in the order that I would like them listed.
Is there a way to reorder part attributes after they are added to the part?
It really is not a big deal for me to delete the attributes and put them back in, but there is one attribute that I cannot delete because I get the error that it is being used in a table or annotation and cannot be deleted ~ but I deleted the annotation that it was used in, and is not being used anyplace, so I should not be getting the error





RE: NX 7.5 Part Attributes
Suresh
www.technisites.com.au