Can anyone tell me how to apply ALE Adaptive meshing for dynamic/explicit
Can anyone tell me how to apply ALE Adaptive meshing for dynamic/explicit
(OP)
Hello Everyone
I am very much new in Abaqus, and not experienced of putting a nice question too...
My problem is.. I am carrying out a cutting simulation with Johnson-Cook material model, 3D stress-explicit-linear (C3D8R) element type and element deletion=YES option. when I run the simulation it shows excessive element distortion. I searched in this forum and other forum, everyone is telling to use ALE adaptive meshing. But no one has given proper steps or procedures to use the ALE adaptive meshing..
Can anyone tell me or give me any suggestion regarding this... will be appreciated greatly..
Thanks in Advance.....
regards...
Borad M Barkachary
IIT Guwahati
I am very much new in Abaqus, and not experienced of putting a nice question too...
My problem is.. I am carrying out a cutting simulation with Johnson-Cook material model, 3D stress-explicit-linear (C3D8R) element type and element deletion=YES option. when I run the simulation it shows excessive element distortion. I searched in this forum and other forum, everyone is telling to use ALE adaptive meshing. But no one has given proper steps or procedures to use the ALE adaptive meshing..
Can anyone tell me or give me any suggestion regarding this... will be appreciated greatly..
Thanks in Advance.....
regards...
Borad M Barkachary
IIT Guwahati





RE: Can anyone tell me how to apply ALE Adaptive meshing for dynamic/explicit
That is not the job of an online volunteer; it is, after all, *your* project. And you have certainly been pointed in the right direction.
Read the FAQs below (in my signature).
http://www.eng-tips.com/faqs.cfm?fid=376
http://www.eng-tips.com/faqs.cfm?fid=1083
RE: Can anyone tell me how to apply ALE Adaptive meshing for dynamic/explicit
RE: Can anyone tell me how to apply ALE Adaptive meshing for dynamic/explicit
Thanks... for ur information