I need to combine two sketches to produce my component.
I need to combine two sketches to produce my component.
(OP)
Hi All,
I am new To NX so there could be a relatively easy solution to this, but I am struggling to Sweep the two profiles shown in the attachment,
Has anyone any advice how I could produce the two combined sketches.
I am currently using NX 6.0
Thanks in advance.
I am new To NX so there could be a relatively easy solution to this, but I am struggling to Sweep the two profiles shown in the attachment,
Has anyone any advice how I could produce the two combined sketches.
I am currently using NX 6.0
Thanks in advance.





RE: I need to combine two sketches to produce my component.
Insert -> Combine Bodies -> Intersect...
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: I need to combine two sketches to produce my component.
Big help that!