Does doing section view using PMI cause assemblies to load slow in NX6
Does doing section view using PMI cause assemblies to load slow in NX6
(OP)
NX6.0.5
If I create section view using the PMI tools , this creates a user view in Model View segment in Part Navigator.. Does this make assemblies load slow? currently Iam seeing that if there is an assembly without the section view using PMI , this loads faster than when I introduce a section view via PMI in that assembly..
Iam in doubt..
If I create section view using the PMI tools , this creates a user view in Model View segment in Part Navigator.. Does this make assemblies load slow? currently Iam seeing that if there is an assembly without the section view using PMI , this loads faster than when I introduce a section view via PMI in that assembly..
Iam in doubt..





RE: Does doing section view using PMI cause assemblies to load slow in NX6
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Does doing section view using PMI cause assemblies to load slow in NX6
Is this true?
RE: Does doing section view using PMI cause assemblies to load slow in NX6
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.