General pattern
General pattern
(OP)
Hi,
I'm not able to obtain the correct result using this general pattern ?
I wrong or this type of pattern use is not supported ?
I'm not able to obtain the correct result using this general pattern ?
I wrong or this type of pattern use is not supported ?
Thank you...
Using NX 8 and TC9.1





RE: General pattern
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.