WF5 - Angle dimensions on drawing
WF5 - Angle dimensions on drawing
(OP)
Hi all,
On WF5 drawing : impossible to put an angle dimension on a element that is under 1° (i.e. 0,5°).
Have you got an solution?
Thanks.
Best regards.
On WF5 drawing : impossible to put an angle dimension on a element that is under 1° (i.e. 0,5°).
Have you got an solution?
Thanks.
Best regards.
MERMET Sebastien
MBF Plastiques - AptarGroup
Pro-E WF5 + PDMlink 9.1
Unigraphics NX4 + TeamCenter 2005
SolidEdge ST3





RE: WF5 - Angle dimensions on drawing
----------------------------------------
The Help for this program was created in Windows Help format, which depends on a feature that isn't included in this version of Windows.
RE: WF5 - Angle dimensions on drawing
Great, thanks.
MERMET Sebastien
MBF Plastiques - AptarGroup
Pro-E WF5 + PDMlink 9.1
Unigraphics NX4 + TeamCenter 2005
SolidEdge ST3