PUSHOVER ANALYSIS by STATC GENERAL (URGENT)
PUSHOVER ANALYSIS by STATC GENERAL (URGENT)
(OP)
Hi, I am currently running a pushover analysis using static general with displacement of 65mm and various axial load as my project is about the effect of axial load in the column by performing pushover analysis. I have tried so many times since past 6 weeks and searched for solution including this forum. Yet I am still not able to solve as I am new to ABAQUS and do not really understand. I know the issue is happen on the time increment as I keep on getting the same error such as too many attempt made for this increment and etc. Is it possible to tell me what I should do ?
Thank you and appreciate
Thank you and appreciate





RE: PUSHOVER ANALYSIS by STATC GENERAL (URGENT)
RE: PUSHOVER ANALYSIS by STATC GENERAL (URGENT)
either way, is there no-one there who can help ?
have you read the manual ? run the example problems ? asked the help desk ?