Sectioned Threaded Shafts
Sectioned Threaded Shafts
(OP)
Dear All,
I'm trying to develop a number of cylindrically threaded components in MDT6.
I can create the models however, when it comes to sectional views I can either have a solid shaft without any representation of thread (this is when I create the shaft using a standard part) or a hatched shaft with thread lines.
What I want for standard representation is a solid shaft in a sectioned hole wshouwing thread representation.
Any ideas ?
Fawkes
I'm trying to develop a number of cylindrically threaded components in MDT6.
I can create the models however, when it comes to sectional views I can either have a solid shaft without any representation of thread (this is when I create the shaft using a standard part) or a hatched shaft with thread lines.
What I want for standard representation is a solid shaft in a sectioned hole wshouwing thread representation.
Any ideas ?
Fawkes




