Is there any file that gives final mass of the model ?
Is there any file that gives final mass of the model ?
(OP)
Hi all,
What is the procedure to get the final mass of the model after running a simulation of erosion type in abaqus ? like in (.dat), we get the initial mass of the model as :
TOTAL MASS OF MODEL
2.4354001E-11
But after using the EVOL output, it was found that the final mass changes to 2.4260001E-11
From where or which file , I could get this value in abaqus?
What is the procedure to get the final mass of the model after running a simulation of erosion type in abaqus ? like in (.dat), we get the initial mass of the model as :
TOTAL MASS OF MODEL
2.4354001E-11
But after using the EVOL output, it was found that the final mass changes to 2.4260001E-11
From where or which file , I could get this value in abaqus?




