detailed thread problems
detailed thread problems
(OP)
Can they be created using a non-standard minor diameter? I tried it and
the results were truly bizarre. Can one add an edge blend (or would a face
blend be better?) to the base of a "tooth" or for that matter, can one add
a chamfer to the top of the tooth? I'm doing an external thread and it comes to
a very thin end and won't let me do these thingsf. Not sure how to get this to work.
TIA
-J
the results were truly bizarre. Can one add an edge blend (or would a face
blend be better?) to the base of a "tooth" or for that matter, can one add
a chamfer to the top of the tooth? I'm doing an external thread and it comes to
a very thin end and won't let me do these thingsf. Not sure how to get this to work.
TIA
-J





RE: detailed thread problems
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: detailed thread problems
J