fill the dwg balloon with the bom
fill the dwg balloon with the bom
(OP)
Hi,
i was wondering if i could make my job easier, by avoiding Typo and gain time.
I am looking for a macro that would take all the part number from a bom (item number being the same as the ballon) , and replace ballons by the part numbers.
Any help would be appreciated.
Thanks!
i was wondering if i could make my job easier, by avoiding Typo and gain time.
I am looking for a macro that would take all the part number from a bom (item number being the same as the ballon) , and replace ballons by the part numbers.
Any help would be appreciated.
Thanks!





RE: fill the dwg balloon with the bom
Win XP64
R20/21, 3DVIA Composer 2012, ST R20
Dell T7400 16GB Ram
Quadro FX 4800 - 1.5GB