Missing Part???? model to drawing
Missing Part???? model to drawing
(OP)
I have added four identical parts (call them foot plates) into my model.
I updated the drawing and in one view 3 of the 4 appear, and in another view only 2 of the 4 show up. I updated more than once, and tried changing reference set from model to entire part which didn't seem to help any. I also tried projecting the view again from scratch, yet still missing the parts? any help would be great.
I updated the drawing and in one view 3 of the 4 appear, and in another view only 2 of the 4 show up. I updated more than once, and tried changing reference set from model to entire part which didn't seem to help any. I also tried projecting the view again from scratch, yet still missing the parts? any help would be great.





RE: Missing Part???? model to drawing
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Missing Part???? model to drawing
I had to delete the existing parts, and re-install the part again.
Then had to redimension the assembly drawing, more time than I wanted to do, but it worked.
Thank you though