coming ''O'' hole in Biaxially oriented polypropylene production time
coming ''O'' hole in Biaxially oriented polypropylene production time
(OP)
Hello,
I m burak başdağ , I worked in a factory about producing BOPP(biaxially oriented polypropylene). We use thin screw extruder and in during production sometimes we encounter with ''O'' hole in streched film. It is happening not so much but, it is important continuous process. Capacity for one day 200 tones.
May be reason thin screw ekstruder?
is there any person to share his/her ideas with me and help us for brain storming for short time
thanks
BOPP Production Engineer.
I m burak başdağ , I worked in a factory about producing BOPP(biaxially oriented polypropylene). We use thin screw extruder and in during production sometimes we encounter with ''O'' hole in streched film. It is happening not so much but, it is important continuous process. Capacity for one day 200 tones.
May be reason thin screw ekstruder?
is there any person to share his/her ideas with me and help us for brain storming for short time
thanks
BOPP Production Engineer.






RE: coming ''O'' hole in Biaxially oriented polypropylene production time
There are some other people who post regularly in this forum that are very knowledgeable in the field of plastics who will likely have better detailed information for you.
It is better to have enough ideas for some of them to be wrong, than to be always right by having no ideas at all.
RE: coming ''O'' hole in Biaxially oriented polypropylene production time
By "o" hole I think you mean a very small round hole.
I don't know if BOPP is blown and stretched or cast and stretched. I expect blown. If so I agree with ornery.
Regards
Pat
See FAQ731-376: Eng-Tips.com Forum Policies for tips on use of eng-tips by professional engineers &
http://eng-tips.com/market.cfm
for site rules
RE: coming ''O'' hole in Biaxially oriented polypropylene production time
Raw material:
Some contamination
Reprocessed material poor quality
Machine:
Electrical resistance damaged, can be burning tha pp or additives
Screw dirty, can be necessary clean
Filter, can be broken
Management:
Overtemperature that can be burning pp or additives
There are much causes, the análisis, is more comletely,