Salt Fog Spray / Corrosion Testing
Salt Fog Spray / Corrosion Testing
(OP)
I'm looking to establish testing qualification criteria for corrosion for wind turbines installed in coastal/offshore applications. Are there any standards that are commonly used across different industries?
Essentially, I would like to set my criteria as "withstand X hours under standard salt fog test conditions." Any recommendations? Where should I start looking?
-Adrian
Essentially, I would like to set my criteria as "withstand X hours under standard salt fog test conditions." Any recommendations? Where should I start looking?
-Adrian





RE: Salt Fog Spray / Corrosion Testing
= = = = = = = = = = = = = = = = = = = =
Plymouth Tube
RE: Salt Fog Spray / Corrosion Testing
http://www.standard.no/PageFiles/1194/M-001.pdf
DNV Recommended Practice CORROSION PROTECTION OF SHIPS
http://exchange.dnv.com/publishing/cn/rp.pdf
DNV Corrosion & Materials Degradation
http://www.dnvusa.com/focus/corrosion_materials_de...
Hempel A/S CORROSION PROTECTION OF OFFSHORE STRUCTURES
http://www.hempel.dk/internet/InecorporateC.nsf/8f...
UK Health & Safety Executive - Offshore oil & gas
http://www.hse.gov.uk/offshore/materials.htm
http://www.hse.gov.uk/offshore/corrosion.pdf
Material Selection Corrosion Prevention Offshore Oil & Gas
http://www.corrosionist.com/Corrosion_Control_Offs...
Corrosion in offshore wind energy - 'a major issue'
http://www.we-at-sea.org/docs/Conference/Session%2...
RE: Salt Fog Spray / Corrosion Testing
RE: Salt Fog Spray / Corrosion Testing
TTFN
FAQ731-376: Eng-Tips.com Forum Policies
RE: Salt Fog Spray / Corrosion Testing