ST4 how to remove unknown coordinate system?
ST4 how to remove unknown coordinate system?
(OP)
Please see attached for illustration.
I have a cylinder part design before ST4, I try to hide the coordinate system but there is a number coordinate system remain. (i draw a line with question mark)
In ST4, I made a new square part and there is no number coordinate system shown even after I hide the coordinate system.
I will appreciate the help to guide me.
I have a cylinder part design before ST4, I try to hide the coordinate system but there is a number coordinate system remain. (i draw a line with question mark)
In ST4, I made a new square part and there is no number coordinate system shown even after I hide the coordinate system.
I will appreciate the help to guide me.





RE: ST4 how to remove unknown coordinate system?
To turn it off go to the mass properties and there are some check boxes there to show/hide mass centre, axes etc.
The clue is the axes are labelled 1,2,3
bc.
2.4GHz Core2 Quad, 4GB RAM,
Quadro FX4600.
Where would we be without sat-nav?
RE: ST4 how to remove unknown coordinate system?