Closure test
Closure test
(OP)
Please, someone tell me wath means closure test ? In B16.34 and API 598 it´s mentioned. Is it the same hydrostatic test of assembled valve ? I need to write a routine of assembled valve hydrostatic test. I´ll use the same pressure that hydrostatic shell test ?
thanks.
thanks.





RE: Closure test
Closure test:pressure test used to confirm leakage past or through a valve closure mechanism.
The closure test pressure obtained as follow:
-low pressure closure test 4-7 barg
-high pressure closure test=110% maximum allowable pressure
As you can see the closure test pressure is different from shall test pressure which is 150%MAWP.
RE: Closure test
RE: Closure test
RE: Closure test
Thanks.
RE: Closure test
Firmino: You will find the answer by following kahn101's advice, and perhaps in addition search this forum for leakage test and pressure tests!
You need to have standard to refer to, describing the quality and standard of your test, in addition (if needed) to your own detailed working procedure. Most such tests will be done with one sided pressure at max given seat test pressure, (see standards) at a given time and given leakage from drop-thight and up, and often also repeated for opposite direction.
RE: Closure test