special sweep
special sweep
(OP)
Can I do this in Nx:
I have profile I want to sweep along a guide, but the profile is not at the guide curve, a second guide spime control curve is avail. The profile should run at the guide....
I have profile I want to sweep along a guide, but the profile is not at the guide curve, a second guide spime control curve is avail. The profile should run at the guide....
sorry new in NX
regards
Erwin





RE: special sweep
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: special sweep
RE: special sweep
sorry new in NX
regards
Erwin
RE: special sweep
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: special sweep
sorry new in NX
regards
Erwin
RE: special sweep
I hope that's clear as to what I mean.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: special sweep
The (Amazing-) Styled Sweep feature can do the desired. See attached image.
( But it might not divide the new surface(s) as in your image. - It probably has to approximate the sweep. )
Regards,
Tomas
RE: special sweep
I have tried the styled sweep, but without success, I'm fighting the many options (to take care)
sorry new in NX
regards
Erwin