NX7.5 - Extrude multiple sections using different individual limits
NX7.5 - Extrude multiple sections using different individual limits
(OP)
Hi,
Catia V5 has a feature named Multipad (similar to Extruded feature in NX) that allows Catia users to extrude at once a sketch with multiple profiles (sections).
I do not think that NX has this capability, but I believe that it would be a good enhancement.
I hope John R. Baker would give us his feedback in this topic.
Thanks
Catia V5 has a feature named Multipad (similar to Extruded feature in NX) that allows Catia users to extrude at once a sketch with multiple profiles (sections).
I do not think that NX has this capability, but I believe that it would be a good enhancement.
I hope John R. Baker would give us his feedback in this topic.
Thanks





RE: NX7.5 - Extrude multiple sections using different individual limits
You will need to utilize the Selection Filter correctly to select what you want;
single curve, entire sketch, tangent curves, etc
There are several threads on this, just do a search
RE: NX7.5 - Extrude multiple sections using different individual limits
Each profile I select would have THE SAME LIMITS!
That’s way I created this subject!
RE: NX7.5 - Extrude multiple sections using different individual limits
I suppresed the three extruded which, normally, show the final model that I need to create.
If someone accept this challenge and maybe able to creat only one extrudion using separate limits for each section, would be great!
RE: NX7.5 - Extrude multiple sections using different individual limits
So why is Catia's way so much better than the way you did it?
RE: NX7.5 - Extrude multiple sections using different individual limits
I use both Catia and NX for years!
To me, NX is better; it has more design options.
It took me 1-2 years to reach this statement.
In this particular thread, Catia offer a simplified solution, by using (only) one feature, instead of three in NX.
Of course, it is not a big deal to create three separate extrusions in NX..........
My point is to highlight a potential enhancement for NX.
I believe that this kind of debates, in time, would be beneficial for a better NX during.
RE: NX7.5 - Extrude multiple sections using different individual limits
You can call the TAC and request an enhancement request, or I think there's a place you can do this on-line too.
RE: NX7.5 - Extrude multiple sections using different individual limits
We, day-by-day users meet the challenge more often and more elaborated than a researcher can do!