ST3 - Cannot Find Pathfinder when editing sheet metal part in place in Assembly.
ST3 - Cannot Find Pathfinder when editing sheet metal part in place in Assembly.
(OP)
I have no idea what happen I was using ST3 Assembly and I was editing a sheet metal part (only in the sheet metal .psm I see it in .par files) when partfinder disappeared I don't know what happen. Ever since when I try editing a sheet metal part in an assemble partfinder does not show up. If I open the part by itself in ST3 partfinder is there.
In the assemble edit in place, If I select a feature on the part I and edit it I can see the partfinder but once I exit I cannot see it. This is driving me crazy right now cause my relationships are out of wack when I cannot see what is happening in edit in place in my assembly. I have even un-installed and reinstalled it.
In the assemble edit in place, If I select a feature on the part I and edit it I can see the partfinder but once I exit I cannot see it. This is driving me crazy right now cause my relationships are out of wack when I cannot see what is happening in edit in place in my assembly. I have even un-installed and reinstalled it.





RE: ST3 - Cannot Find Pathfinder when editing sheet metal part in place in Assembly.
You might have better luck in the SolidEdge forum
forum562: Siemens: Solid Edge
www.nxjournaling.com
RE: ST3 - Cannot Find Pathfinder when editing sheet metal part in place in Assembly.
RE: ST3 - Cannot Find Pathfinder when editing sheet metal part in place in Assembly.
RE: ST3 - Cannot Find Pathfinder when editing sheet metal part in place in Assembly.
http://www.eng-tips.com/threadminder.cfm?pid=562
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.