DXF Output
DXF Output
(OP)
Hello,
For some reason I cannot export a drawing in DXF format.
The engineer right next to me is running the same version of Pro/E (2001) and can export DXF all day long.
Would anyone know why this may be happining????
For some reason I cannot export a drawing in DXF format.
The engineer right next to me is running the same version of Pro/E (2001) and can export DXF all day long.
Would anyone know why this may be happining????





RE: DXF Output
If it is its because you have fast HLR switched on.
switch it off and you should find the DXF icon is now active.
RE: DXF Output
This is true in both 2000i2 and 2001. You can also hit no hiddenlines after the dxf is availabel and it will stay. You have to do this each time.
Ishman
RE: DXF Output
d:\PTC\proe2001\test\intf_configs\dxf_export.pro you'll find the setup for the conversion of the lines from Pro/e to DXF. We use a software package called MEDUSA which was once owned by PTC. But we have only just found out about it's config file and we've had Proe for 5 years. So ask your tech support for a configuration file for DXF. Hope this helps
RE: DXF Output
Thanks again you guys are the best.
John Follo