Part size too large
Part size too large
(OP)
Hi.
There is something happening that I can not understand why. I've recently made a model of a curve by subtracting interference bodies from a disc to create a sort of a cam.
When I finished it I saw that the part size was arround 5mb due to all the subtractions I made.
Now that I'm trying to do the same part again. For a reason that I'm trying to find I didnt saved a backup copy of it, but now I'm doing exactly the same process but even before reaching the middle of the modeling the file size goes to 238mb and NX stops responding or just take to much time to do it.
Any reason why that is possibly happening?
There is something happening that I can not understand why. I've recently made a model of a curve by subtracting interference bodies from a disc to create a sort of a cam.
When I finished it I saw that the part size was arround 5mb due to all the subtractions I made.
Now that I'm trying to do the same part again. For a reason that I'm trying to find I didnt saved a backup copy of it, but now I'm doing exactly the same process but even before reaching the middle of the modeling the file size goes to 238mb and NX stops responding or just take to much time to do it.
Any reason why that is possibly happening?





RE: Part size too large
RE: Part size too large
I think my computer specs are good since I already did the part once before, I'm just trying to do it again. I'm runing it on a 16Gb RAM and intel i7 processor.
Would it be a solution if I run a scan disk and defragmentation on the hard disk?
RE: Part size too large
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Part size too large