Partial section missing many components
Partial section missing many components
(OP)
I'm trying to create a section of an assembly. I've tried using the section view in the drawing, I've also tried to save an anotation view using the section in the model.
Both, when inserted in to the drawing, have many missing components. Some parts and some full assemblies are not shown.
Attached is a screen shot of what I'm getting.
Both, when inserted in to the drawing, have many missing components. Some parts and some full assemblies are not shown.
Attached is a screen shot of what I'm getting.






RE: Partial section missing many components
RE: Partial section missing many components
RE: Partial section missing many components
RE: Partial section missing many components
RE: Partial section missing many components
Han primo incensus
RE: Partial section missing many components
RE: Partial section missing many components
Turns out it was a server error of sorts. It wasn't picking up the other assemblies off of the server. Which is weird, because the assemblies were showing up in the plan view, but not on the section/elevation.
I rebooted this morning, and when I opened up the drawing, the view was magically there!
Thanks for the replies!
RE: Partial section missing many components