Hole Table
Hole Table
(OP)
Doesn't seem to work correctly anymore. Can't create origins from sketched entities or points. What do you do when the part doesn't lend itself to a circle in the center of the part to set your zero to?
When was the last time you drove down the highway without seeing a commercial truck hauling goods?
Download nowINTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS Come Join Us!Are you an
Engineering professional? Join Eng-Tips Forums!
*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail. Posting GuidelinesJobs |
|
RE: Hole Table
Make sure your sketch is in the correct drawing view, and not on the drawing template or different view.
-Lou
RE: Hole Table
SW Premium 2011
64 bit SP4.0
Intel Xenon X5650 @2.67GHz
2.66 GHz 11.9 GB of RAM