Failure analisys in NX
Failure analisys in NX
(OP)
I have a request to determine the failure mode analisys of a simple hose barb does NX have a tool to determine the breaking point if a load were placed at a specific area? Is it an additional license requirement? guidance using the tool would be appreciated.
Thank you
Thank you





RE: Failure analisys in NX
http://www.plm.automation.siemens.com/en_us/produc...
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.