Why even number of nodes around holes
Why even number of nodes around holes
(OP)
Hello everyone,
Can anybody please tell me that why we maintain even number of nodes around holes while meshing a model?
Thank you
Can anybody please tell me that why we maintain even number of nodes around holes while meshing a model?
Thank you





RE: Why even number of nodes around holes
RE: Why even number of nodes around holes
but then it's no harder to divide into an odd number either !
'cause you get a nice looking "fan" pattern of the elements ...
nothing suggests that the virtual world will come crashing down on you, invalidating your results, if you use an odd number of elements.
unless, of course, your customer has specified doing this ...
in which case the very real contract world will come avisiting your cubie.
RE: Why even number of nodes around holes
http://julianh72.blogspot.com
RE: Why even number of nodes around holes
just make sure there are atleast 4 elements per quadrant
RE: Why even number of nodes around holes