Hi all, Is there an easy way of cr
Hi all, Is there an easy way of cr
(OP)
Hi all,
Is there an easy way of creating a (module) gear tooth profile in NX7.5. Thanks for any help. Will help any one out when I get more used to the system. Thanks all.
Is there an easy way of creating a (module) gear tooth profile in NX7.5. Thanks for any help. Will help any one out when I get more used to the system. Thanks all.





RE: Hi all, Is there an easy way of cr
Best regards,
Michaël.
NX7.5.4.4 + TC Unified 8.3
Win 7 64 bit (Intel(R) Xeon(R) CPU X5650 @2.67GHz)
24.0 GB
NVIDIA Quadro 4000 + NVIDIA Tesla C2050
RE: Hi all, Is there an easy way of cr