Drafting dementions
Drafting dementions
(OP)
I'm trying to put a box around my diameter demention in UG-nx 7.5
the link below shows what i want to do. i could use the note and make it look the same but i want it to change when i change the part... any suggestions?
1 year in the feild
the link below shows what i want to do. i could use the note and make it look the same but i want it to change when i change the part... any suggestions?
1 year in the feild





RE: Drafting dementions
John Lackowski
NX Support
Win 7 64bit NX 7.5.4.4 TC 8.3.1.1
RE: Drafting dementions
RE: Drafting dementions