Multiviews in NX
Multiviews in NX
(OP)
Hi all,
Today I opended old *.prt file (created in maybe NX V17, not by me). How to switch off miltiviews in modelspace (see attached picture)?
Thanks.
NX7
win7 64bit.
Today I opended old *.prt file (created in maybe NX V17, not by me). How to switch off miltiviews in modelspace (see attached picture)?
Thanks.
NX7
win7 64bit.





RE: Multiviews in NX
View -> Layout -> Open...
...and select the 'L1 - single view' layout from the list and hit OK.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: Multiviews in NX
I was struggling all the morning with these multiviews with no result :)