break out single component in view
break out single component in view
(OP)
Is there a way to break out a single component in an assembly drawing view. Large assembly view with air and oil lines entering a housing. I want to see the piping entering the housing but don't want the clutter of the pipes in the center of the housing. The broken view breaks the entire view. Is there a way to be selective?





RE: break out single component in view
RE: break out single component in view
You should be able to figure it out from there, but if you have questions please post them.
RE: break out single component in view
http://www.eng-tips.com/viewthread.cfm?qid=281170
When I work with piping or hosing I never want them sectioned in the assembly so I do what John mentions above
RE: break out single component in view
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: break out single component in view
NX 6.0.5.3 in Windows 7
Mechanical designer
RE: break out single component in view
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: break out single component in view
RE: break out single component in view