Importing reactions from floor above as loads in SAFE model
Importing reactions from floor above as loads in SAFE model
(OP)
Is there a way to import the reactions from one SAFE model and apply them as loads in a new model?
Basically, I have a 5 story building with concrete slabs supported on walls that do not stack. The reactions on the walls vary along the length of the wall due to the complex geometry. Inputting all this by hand has proven tedious.
Basically, I have a 5 story building with concrete slabs supported on walls that do not stack. The reactions on the walls vary along the length of the wall due to the complex geometry. Inputting all this by hand has proven tedious.




