NX6 COMPONENT PART FAMILY
NX6 COMPONENT PART FAMILY
(OP)
Hi,
I am new NX6 user and have question abut the component part family. I modeled MASTER component, also populated the part family, say 1,2,3 and so on.
The problem is , when I open the draft still I get the master drawing and I am unable to save children.
Does part family in NX works same as Solid Edge or is there anything which is similar to that in NX?
Basically, I have MASTER and need children with drawings.
I am new NX6 user and have question abut the component part family. I modeled MASTER component, also populated the part family, say 1,2,3 and so on.
The problem is , when I open the draft still I get the master drawing and I am unable to save children.
Does part family in NX works same as Solid Edge or is there anything which is similar to that in NX?
Basically, I have MASTER and need children with drawings.




