nodes coordinate
nodes coordinate
(OP)
Hi , I am using Abaqus CAE to simulate hertzian contact , there are about 2000 nodes in active area of contact in the master surface , I would like to get the pressure contact value and the coordinate for each node in a tabular form , I can get them via choosing the nodes one by one ( but it is too slow and difficult ) way , so please I need help to get the pressure value and the coordinate for each node in a tabular form , Thanks a lot .





RE: nodes coordinate
*Output, history, nset=relevant_nodes
coord, cpress
or similar I dont have the manual here. Then enter the A/viewer and XY-plot create and plot coord ans cpress in the same diagramme
RE: nodes coordinate
http://www.eng-tips.com/faqs.cfm?fid=376