NXOpen generated PMI annotations
NXOpen generated PMI annotations
(OP)
I'm having an issue with an NXOpen routine I wrote. It generates General Note PMIs based on some information, then posts it onto the screen. It works fine for other users except for one in particular. Whenever he runs the routine, the PMI is generated, but instead of solid lines it is displayed as dashed line which render it illegible. If he creates a PMI note by hand, the resulting note comes out normally. I cannot find any options that allow for the display of PMI Notes as dashed lines, and I cannot find any attributes that support setting it through NXOpen.
Any help is appreciated!
Bruce
Any help is appreciated!
Bruce





RE: NXOpen generated PMI annotations
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.