View regenerating in Drafting
View regenerating in Drafting
(OP)
NX 7.5.0.32, windows 7 64 bit, dual Nvidia Quadro 4000 cards.
While in NX drafting, my views sometimes does not display all of the view. Whenever this happens I must regenerate my view to get it to display fully. Is there a setting that will correct this from ever happening?
Rob
While in NX drafting, my views sometimes does not display all of the view. Whenever this happens I must regenerate my view to get it to display fully. Is there a setting that will correct this from ever happening?
Rob





RE: View regenerating in Drafting
Anthony Galante

Technical Resource Coordinator
NX4.0.4MP10, NX5.0.6, NX6.0.5, NX7.0.1, NX7.5.0-> NX7.5.5 & NX8.0.0 -> NX8.0.2, NX8.5p15
RE: View regenerating in Drafting
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
RE: View regenerating in Drafting
Updated to NX 7.5.5.4 ......fixed
Rob