Hi, I am trying to configure the
Hi, I am trying to configure the
(OP)
Hi,
I am trying to configure the ICEM UG mesher interface 12.1 for use with 64bit NX7.5 (ie use the ICEM mesher from wirhin NX) I did this for NX6 (32bit)
ICEM (64bit) works fine on the client, but i cant get it to work with NX7.5 (64bit). Any tips for somthing obvious i am missing?
Cheers
NXj
I am trying to configure the ICEM UG mesher interface 12.1 for use with 64bit NX7.5 (ie use the ICEM mesher from wirhin NX) I did this for NX6 (32bit)
ICEM (64bit) works fine on the client, but i cant get it to work with NX7.5 (64bit). Any tips for somthing obvious i am missing?
Cheers
NXj




