NX 7.5 Annotation Notes Too Small?
NX 7.5 Annotation Notes Too Small?
(OP)
My company is switching from SolidWorks to NX 7.5. I have several drawings that needed to be copy over to NX 7.5. When copy from SolidWorks to NX 7.5 through the use of annotation, I notice that part of the note got cropped off and not shown. I went to customer default in NX setting and change the text editor box size, but still have no luck in making my text appear on screen. Any help would be appreciated. Thanks.
Mechanical Design Engineer
Aerospace and Research Industry
NX 7.5 & SolidWorks





RE: NX 7.5 Annotation Notes Too Small?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 7.5 Annotation Notes Too Small?
Mechanical Design Engineer
Aerospace and Research Industry
NX 7.5 & SolidWorks
RE: NX 7.5 Annotation Notes Too Small?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 7.5 Annotation Notes Too Small?
Mechanical Design Engineer
Aerospace and Research Industry
NX 7.5 & SolidWorks
RE: NX 7.5 Annotation Notes Too Small?
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.