[NX 7] Tollerance on 3D dimension
[NX 7] Tollerance on 3D dimension
(OP)
Hi,
we don't have PMI license.
I tried to add tolerance to sketch dimensions, but when I add this dimension on drafting via 'Feature Parameters' command, tolerances aren't added.
It's possible without PMI license, use 3D sketch tolerances imported in drafting and an update if I change tolerances in 3D ?
Thank you...
Using NX 8 and TC8.3





RE: [NX 7] Tollerance on 3D dimension
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.