FEM on UG
FEM on UG
(OP)
Hello,
I'm learning to use UG and I'd like to know how the FEM works.
I want to do this through an exemple of a square 10''long bar of 2in sides fixed at one end and free at the other where a vertical force is applied to the bar horizontaly placed.
Can any one give me the steps to follow, brief ones so I can get familiar with it?
Thank you
I'm learning to use UG and I'd like to know how the FEM works.
I want to do this through an exemple of a square 10''long bar of 2in sides fixed at one end and free at the other where a vertical force is applied to the bar horizontaly placed.
Can any one give me the steps to follow, brief ones so I can get familiar with it?
Thank you





RE: FEM on UG
There should be an example of how to do an analysis in there.
What version of NX are you on?
"Wildfires are dangerous, hard to control, and economically catastrophic."
Ben Loosli