trim curve
trim curve
(OP)
NX8
i want to turn off the associtive switch under- trim curve- settings
so when i start a new session it stays off. i can toggle it off per session but would rather it stay off for good.
i want to turn off the associtive switch under- trim curve- settings
so when i start a new session it stays off. i can toggle it off per session but would rather it stay off for good.





RE: trim curve
However, if you want it to never have it toggled ON in the first place, go to...
Customer Defaults -> Curves -> Curve Associativity -> All
...and toggled OFF the 'Trim Curve' option.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: trim curve
RE: trim curve
Customer Defaults -> Gateway -> User Interface -> General
...and check to make sure that the 'Save Dialog Box Settings between Sessions' option is toggled ON.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: trim curve
DialogMemory.dlx file. It makes a new one upon every exit of UG.
Upon doing that it started working, i believe it was hung up there.
Thanks