Tolerance Stackup Validation
Tolerance Stackup Validation
(OP)
Where could I find the Tolerance Stackup Validation toolbar?
I remembered that It was a environment in NX6.
The help says: Analysis→Tolerance Stackup Validation, but there is not there.
I remembered that It was a environment in NX6.
The help says: Analysis→Tolerance Stackup Validation, but there is not there.





RE: Tolerance Stackup Validation
Help (pull-down) -> Command Finder
It is also on your "Standard" toolbar.
RE: Tolerance Stackup Validation
Attila Szepesi
support engineer
graphIT Ltd.
www.graphit.hu
RE: Tolerance Stackup Validation
www.nxjournaling.com
RE: Tolerance Stackup Validation
Attila Szepesi
support engineer
graphIT Ltd.
www.graphit.hu