[NX 8] Component as Reference
[NX 8] Component as Reference
(OP)
Hi,
I don't understand or maybe I need to set something else, but after customer default setting and make the assembly as reference, the ANT show again the sub-assembly weight.
Can you help me to understand how to configure a sub-assembly as reference and exclude from weight calculation without some special weight management license ?
I don't understand or maybe I need to set something else, but after customer default setting and make the assembly as reference, the ANT show again the sub-assembly weight.
Can you help me to understand how to configure a sub-assembly as reference and exclude from weight calculation without some special weight management license ?
Thank you...
Using NX 8 and TC8.3





RE: [NX 8] Component as Reference
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.