NX 7.5 Part Families
NX 7.5 Part Families
(OP)
I have an assembly with 3 components named generically. Top, Bot, Middle. I would like to create a part family and rename the generic names to official names. I have tried this a few times but it seems to be looking to replace the generic named model with the official named file. Does anyone know about this?
Thanks,
Thanks,





RE: NX 7.5 Part Families
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX 7.5 Part Families
RE: NX 7.5 Part Families
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.