NX7.5 2D Cross section along an Arc.
NX7.5 2D Cross section along an Arc.
(OP)
I am trying to create a cross section that goes in an arc.
Please see pic for clarification.
What would be the correct or recommended process in NX drafting to accomplish this.
The attached image was done with I-Deas.
Please see pic for clarification.
What would be the correct or recommended process in NX drafting to accomplish this.
The attached image was done with I-Deas.





RE: NX7.5 2D Cross section along an Arc.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: NX7.5 2D Cross section along an Arc.
Thanks for the feedback.
RE: NX7.5 2D Cross section along an Arc.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.