Tighten up welding symbols
Tighten up welding symbols
(OP)
I searched and can not find the setting location to control the spacing in welding symbols to tighten up the vertical space between the symbol and the "grind flat" modifiers. The default spacing is very large. Does anyone know where to adjust this. See attached image for example.





RE: Tighten up welding symbols
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Tighten up welding symbols
RE: Tighten up welding symbols
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.