Dimensions associatively from NX4 to NX7.5
Dimensions associatively from NX4 to NX7.5
(OP)
Hi. We just upgraded from NX4 to NX7.5. When I open any drawing created in NX4 in NX7.5 it loses all dimension associatively. Is there a way to stop this without having to reattach every dimension? Thanks





RE: Dimensions associatively from NX4 to NX7.5
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.