NX Hole Table - Custom Headings
NX Hole Table - Custom Headings
(OP)
Is there a way to edit the hole table in NX Drafting. What I mean is The default hole table combines the holes into groups, which we do not want. See Attached File.
I can't figure out where the hole table is pulling the information from, therefore I cannot edit what information goes where. Any Help editing the table would be great
I can't figure out where the hole table is pulling the information from, therefore I cannot edit what information goes where. Any Help editing the table would be great





RE: NX Hole Table - Custom Headings
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.