Issue after installing NX8 update
Issue after installing NX8 update
(OP)
Hi everyone,
I'm having a strange issue after installing the update for NX8. When I start the program it comes up with a 'No disk' error, if I put the disk in the drive or cancel (sometimes have to do this several times) it starts.
Any ideas much appreciated.
I'm having a strange issue after installing the update for NX8. When I start the program it comes up with a 'No disk' error, if I put the disk in the drive or cancel (sometimes have to do this several times) it starts.
Any ideas much appreciated.





RE: Issue after installing NX8 update
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.