Helix with roundsel
Helix with roundsel
(OP)
Hi,
I want to draw a helix that you can find in the image but I don't know how to do it in siemens nx 7.5.
I can draw the helix but the round rings at the end I can't draw. This round things are neeedfull to connect it with another part so that the helix is parallel with a bar.
I folowed this link already: http://www.eng-tips.com/viewthread.cfm?qid=243111 but it didn't work for me.
So I hope someone can help me out.
Thanks in forward.
Stijn K.
I want to draw a helix that you can find in the image but I don't know how to do it in siemens nx 7.5.
I can draw the helix but the round rings at the end I can't draw. This round things are neeedfull to connect it with another part so that the helix is parallel with a bar.
I folowed this link already: http://www.eng-tips.com/viewthread.cfm?qid=243111 but it didn't work for me.
So I hope someone can help me out.
Thanks in forward.
Stijn K.





RE: Helix with roundsel
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.