Adding assembly mass to drafting note
Adding assembly mass to drafting note
(OP)
Hi I'm trying to add the total assembly solid mass to a drafting note that will update if the panel sizes change. I've taken the assembly and in modeling "measured bodies" to get the mass and checked "Associative" to get the number to be added to the assembly history (expression p1841). Now in the drawing file in drafting I have a note estimated final mass X kg. For the X place holder I tried adding <part name:p1841>. That is definitely not correct. Not sure the proper code to display this expression in the drafting note. Help please!





RE: Adding assembly mass to drafting note
Anthony Galante

Technical Resource Coordinator
NX4.0.4MP10, NX5.0.6, NX6.0.5, NX7.0.1, NX7.5.0-> NX7.5.5 & NX8.0.0 -> NX8.0.1
RE: Adding assembly mass to drafting note
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.
RE: Adding assembly mass to drafting note
RE: Adding assembly mass to drafting note
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
http://www.siemens.com/plm
UG/NX Museum: http://www.plmworld.org/p/cm/ld/fid=209
To an Engineer, the glass is twice as big as it needs to be.