×
INTELLIGENT WORK FORUMS
FOR ENGINEERING PROFESSIONALS

Log In

Come Join Us!

Are you an
Engineering professional?
Join Eng-Tips Forums!
  • Talk With Other Members
  • Be Notified Of Responses
    To Your Posts
  • Keyword Search
  • One-Click Access To Your
    Favorite Forums
  • Automated Signatures
    On Your Posts
  • Best Of All, It's Free!
  • Students Click Here

*Eng-Tips's functionality depends on members receiving e-mail. By joining you are opting in to receive e-mail.

Posting Guidelines

Promoting, selling, recruiting, coursework and thesis posting is forbidden.

Students Click Here

Jobs

VFD's

VFD's

(OP)
Hey All,

Wanted to know if anyone on the forum has run across motor bearings pitting because of bearing currents caused by common mode voltages from VFD's.  I've a situation at my plant where this phenomenon is occurring.  We've decided on shaft grounding kits to alleviate this problem.  Any others w/ similar problems?

Mike

RE: VFD's

I appreciate the circulating bearing currents could come from a number of sources.  In turn this can pit the bearings leading to premature failure.  One I saw in a 398-amp 50 Hz 415 volt motor was caused by nothing more than the ground conductor being run neatly alongside the same phase conductor (they were single-core double-insulated conductors) over the route length of about 100 metres.  Current measured in the ground conductor was 90 amps.  I think the drive end bearing lasted just over two years.  Separating the ground by about 300 mm from the trefoil of the phases reduced the current to just a couple of amps.  

RE: VFD's

You should check out the Sept/Oct issue of IEEE Industry Applications Magazine which contains an article on motor bearing fluting.  There have also been numerous technical papers written over the past few years regarding this problem and means to mitigate it.

Red Flag This Post

Please let us know here why this post is inappropriate. Reasons such as off-topic, duplicates, flames, illegal, vulgar, or students posting their homework.

Red Flag Submitted

Thank you for helping keep Eng-Tips Forums free from inappropriate posts.
The Eng-Tips staff will check this out and take appropriate action.

Reply To This Thread

Posting in the Eng-Tips forums is a member-only feature.

Click Here to join Eng-Tips and talk with other members!


Resources